Opton fiber optic distribution box with dimensions of 55x31x20 cm. It has two pairs of doors, allowing the separation of two parts - one line and one subscriber. In addition, the entire front module has hinges and can be opened - underneath there are cable holders (see photos). The additional module has a depth of 57 mm and is also divided into two parts. The door is closed with 4-pin locks, ensuring proper protection of the cables. In the top and bottom wall of the box  there are 4 ribs (to be knocked out) with a diameter of 38/29 mm, additionally there are 2 ribs on the side wall. Placed inside the frame allows  to mount 48 SC Duplex or LC Quad adapters. Using the  full ammount of the SC adapter, up to 96 optical fibers can be connected, while using LC  adapters- up to 192 fibers. The distribution box  is  made of 1 mm thick steel sheet, the whole is covered with a Magnelis coating and powder coated in light gray RAL7035.

In the linear part there is a tilting tray on which the optical splitter can be mounted, on it there is a space for the cable and a  welds tray . The entire panel can be dismantled and attached in one of the box parts (magnet mounting). In an easy and convenient way, the main cable  can be prepared in an easy and convinient way to separate the PON signal between clients. In the subscriber part there is a screw for mounting the welding trays, as well as space for an additional supply of cable.

The offered product is perfectly suited to the PON (FTTH) network implemented in buildings.The  mounting of  this type of box, for egsample  in the basement, allows you to prepare the main cable, mount the splitter, and then easily and quickly connect new subscribers. At the same time, all cable ends are properly protected against unwanted interference.

Warning!The ! Fiber optic accessories shown in the picture (trays, cable, splitter) are not included in the kit.

The most important features:

•      fiber optic distribution box
•     frame for 48 SC duplex or LC Quad adapters;
•     two-access switchgear - two pairs of doors, division into a linear and distribution part;
•     front tilting module - there is space for the cable at the bottom;
•     space for cable storage and splitter assembly;
•     adapted for wall mounting.

Specification